Network Operation and Remote Control
R&S
®
SMW200A
721User Manual 1175.6632.02 ─ 16
The remote commands required to configure the emulation settings remotely are
described in Chapter 13.19, "SYSTem Subsystem", on page 1115.
Language
Selects the instrument whose remote command set is emulated by the R&S SMW.
Remote command:
:SYSTem:LANGuage on page 1130
Mode
Selects the way the instrument identification is performed.
"Automatic"
Sets the "IDN String" and the "OPT String" automatically for the
instrument selected with the parameter Language.
"User Defined"
Enables you to define the "IDN String" and the "OPT String".
Remote command:
:SYSTem:IDENtification on page 1129
Set to Default
In "Mode > User Defined", resets the *IDN and *OPT strings.
Remote command:
:SYSTem:IDENtification:PRESet on page 1130
IDN String
Indicates the identification string of the instrument when queried with the common
command *IDN?.
In addition to the preset values, you can define your own identification string so that
each generator uses an individual identification, like My_SigGen for instance.
Remote command:
*IDN? on page 770
OPT String
Indicates the option string of the instrument as queried with common command *OPT?.
In "Mode > User Defined", you can define your own option string, additionally to the
automatically created one.
Remote command:
*OPT? on page 771
12.4.6 Active Connections Settings
Access:
► Select "System Config > Remote Access > Active Connections".
Remote Access Settings
To Next Page
Loading...
