Remote Control Commands
R&S
®
SMW200A
1130User Manual 1175.6632.02 ─ 16
Parameters:
<Identification> AUTO | USER
AUTO
Automatically determines the "IDN String" and the "OPT String".
USER
Enables the selection of user definable "IDN String" and "OPT
String".
*RST: n.a. (factory preset: AUTO)
Example:
SYST:IDEN AUTO
automatically asigns the OPT and IDN strings accoording to the
selected instrument language.
Manual operation: See "Mode" on page 721
:SYSTem:IDENtification:PRESet
Sets the *IDN and *OPT strings in user defined mode to default values.
Example:
SYST:IDEN USER
SYST:IDEN:PRES
Usage: Event
Manual operation: See "Set to Default" on page 721
:SYSTem:LANGuage <Language>
Sets the remote control command set.
Parameters:
<Language> string
Example:
SYSTem:LANGuage "SCPI"
// selects SCPI command set
Manual operation: See "Language" on page 721
:SYSTem:INFormation:SCPI <InfoString>
Inserts system information in recorded SCPI command lists, for example information
on a missing command.
Parameters:
<InfoString> string
Example:
SYST:INF:SCPI "missing command"
enters the information into a recorded SCPI command list.
:SYSTem:SPECification? <Id>
Retrieves data sheet information for a specific parameter.
SYSTem Subsystem
To Next Page
Loading...
