Network Operation and Remote Control
R&S
®
SMW200A
731User Manual 1175.6632.02 ─ 16
The dialog shows all specified resource strings of the supported remote control
interfaces.
●
For information on how to assign the IP address manually, see Chapter 2.1.4.3,
"Assigning the IP Address", on page 48.
●
Also note that using the RS232 serial interface via USB requires the USB serial
adapter R&S TS-USB1.
12.7 How to Change the GPIB Instrument Address
To control the instrument remotely via the GPIB bus, it must be addressed using the
GPIB address. The remote control address is factory-set to 28, but it can be changed if
it does not fit in the network environment. For remote control, addresses 0 through 30
are allowed. The GPIB address is maintained after a reset of the instrument settings.
To set the GPIB address:
1. Select "System Config > Remote Access > GPIB Address".
2. Select "GPIB Channel Address" and enter a value between 0 and 30.
Risk of losing remote connection
Since a Factory Preset resets the remote access and network settings to the default
values, executing factory preset via remote control terminates the connection to the
instrument, if these settings had been configured to values different to the default ones!
How to Change the GPIB Instrument Address
To Next Page
Loading...
