Rohde & Schwarz SMW200A - Power Ramping

Remote Control Commands
R&S
®
SMW200A
903User Manual 1175.6632.02 ─ 16
Manual operation: See "State Modulation <=> CW Switching" on page 276
Power Ramping
[:SOURce<hw>]:BB:DM:PRAMp:SOURce <Source>
Sets the source for the power ramp control signals.
Parameters:
<Source> INTernal
*RST: INTernal
Example: See Example "Enable power ramping" on page 893
Options: R&S SMW-B10
Manual operation: See "Source" on page 279
[:SOURce<hw>]:BB:DM:PRAMp:SHAPe
<Shape>
Sets the edge shape of the ramp envelope.
Parameters:
<Shape> LINear | COSine
*RST: COSine
Example: See Example "Enable power ramping" on page 893
Options: R&S SMW-B10
Manual operation: See "Ramp Function" on page 279
[:SOURce<hw>]:BB:DM:PRAMp:TIME <Time>
Sets the power ramping rise time and fall time for a burst.
Parameters:
<Time> float
Range: 0.25 to 16
Increment: 0.01
*RST: 1
Default unit: symbol
Example: See Example "Enable power ramping" on page 893
Options: R&S SMW-B10
Manual operation: See "Ramp Time" on page 279
[:SOURce<hw>]:BB:DM:PRAMp:FDELay <FDelay>
[:SOURce<hw>]:BB:DM:PRAMp:RDELay <RDelay>
Sets the delay in the rising edge.
SOURce Subsystem