Rohde & Schwarz SMW200A - Page 917

Remote Control Commands
R&S
®
SMW200A
902User Manual 1175.6632.02 ─ 16
Parameters:
<Deviation> float
The value range depends on the symbol rate.
Range: 1 to 40E6
Increment: 0.5
*RST: 135416.5
Example:
SOURce:BB:DM:FORMat FSK4
SOURce:BB:DM:FSK:DEViation 1MHZ
Manual operation: See "FSK Deviation" on page 275
[:SOURce<hw>]:BB:DM:FSK:VARiable:SYMBol<ch0>:DEViation
<Deviation>
Sets the deviation of the selected symbol for variable FSK modulation mode.
Parameters:
<Deviation> float
The value range depends on the selected symbol rate (see data
sheet).
Range: -40E6 to 40E6
Increment: 0.5
Default unit: Hz
Example:
SOURce:BB:DM:FORMat FSKVar
SOURce:BB:DM:FSK:VARiable:TYPE FSK4
SOURce:BB:DM:FSK:VARiable:SYMBol0:DEViation 135000
Manual operation: See "Deviation xxxx" on page 275
[:SOURce<hw>]:BB:DM:FSK:VARiable:TYPE <Type>
The command selects the modulation type for Variable FSK.
Parameters:
<Type> FSK4 | FSK8 | FSK16
*RST: FSK4
Example: See [:SOURce<hw>]:BB:DM:FSK:VARiable:
SYMBol<ch0>:DEViation on page 902
Manual operation: See "FSK Type" on page 275
[:SOURce<hw>]:BB:DM:SWITching:STATe <State>
Enables switching between a modulated and an unmodulated signal.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce1:BB:DM:SWITching:STATe ON
SOURce Subsystem