Configuring the Signal in the RF Domain
R&S
®
SMW200A
474User Manual 1175.6632.02 ─ 16
Live list processing mode
The R&S SMW generates the signal directly from the value pairs in the database, and
adjusts the hardware settings accordingly. The current instrument state and thus any
change during the signal generation directly affects the RF signal. The temporary
memory is not used.
You can conveniently modify parameters like modulation settings during run-time.
Learning list mode data is not required. Impacts like temperature drift are also consid-
ered immediately.
This mode is optimized for maximum signal quality, and is useful if dwell times higher
than 2 ms are sufficient.
7.6.5 Sweep Mode Settings
Since all sweep modes use the similar parameters to be configured, the description
comprises the settings of the three dialogs, "RF Freq Sweep", "RF Level Sweep" and
"LF Freq Sweep". If parameters relate to only particular modes, they are pointed out.
The corresponding remote-control commands are always listed in the same order as
mentioned above, recognizable by the syntax.
Access:
► Select the corresponding sweep mode:
● ""RF" > "Sweep/List"" > "RF Frequency Sweep".
● ""RF" > "Sweep/List"" > "RF Level Sweep".
● ""RF" > "Sweep/List"" > "LF Frequency Sweep".
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
