Rohde & Schwarz SMW200A - Page 490

Configuring the Signal in the RF Domain
R&S
®
SMW200A
475User Manual 1175.6632.02 ─ 16
Table 7-9: R&S SMW Sweep Mode dialogs
RF Frequency Sweep RF Level Sweep LF Frequency Sweep
In these dialogs, you can configure the corresponding sweep signal.
The remote commands required to define these settings are described in:
●
Chapter 13.18.6, "SOURce:FREQuency Subsystem", on page 1037
●
Chapter 13.18.17, "SOURce:SWEep Subsystem", on page 1106
●
Chapter 13.18.10, "SOURce:LFOutput Subsystem", on page 1061
Settings
State (RF frequency sweep)....................................................................................... 476
State (RF level sweep)................................................................................................476
State (LF frequency sweep)........................................................................................476
Mode........................................................................................................................... 476
Specific Sweep Parameters........................................................................................477
└ Mode.............................................................................................................477
Varying the RF Signal in List or Sweep Mode