Rohde & Schwarz SMW200A - Segment Table

Configuring the Internal Baseband Source
R&S
®
SMW200A
333User Manual 1175.6632.02 ─ 16
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe on page 942
Create/Create and Load
●
"Create"
Creates a multi-segment waveform using the current entries in the Segment Table.
●
"Create and Load"
Creates a multi-segment waveform and loads it in the ARB generator.
The R&S SMW stores the multi-carrier waveform as file with file name as specified with
parameter Output file.
Depending on the configuration of the multi-carrier waveform, calculation takes some
time. Use the "Abort" function, to interrupt the calculation.
Remote command:
To define the configuration file (*.inf_mswv) used by the calculation of the output file:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
Or [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
To define the file name of the output waveform file (*.wv):
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
4.8.3.2 Segment Table
Access:
1. Select "Baseband > ARB > General > Multi Segment".
2. In the "ARB: Multi Segment > General" dialog, select an existing list.
3. Select "ARB: Multi Segment > Segment Table".
4. Select "Append" to add existing waveform segments.
5. Select "Append Blank" to add a bank segment and configure the "Blank Segment
Settings" as required.
Generating Multi-Segment Waveform Files