Rohde & Schwarz SMW200A - (Delta) RF Frequency; RF Level; External Instrument Configuration Settings; RF State

Signal Routing and System Configuration
R&S
®
SMW200A
154User Manual 1175.6632.02 ─ 16
Remote command:
:SCONfiguration:EXTernal:FADer<ch>:RF:COUPling on page 847
:SCONfiguration:EXTernal:BBMM<ch>:RF:COUPling on page 847
:SCONfiguration:EXTernal:IQOutput<ch>:RF:COUPling on page 847
(Delta) RF Frequency/ RF Level
In uncoupled mode, sets the RF frequency and RF level of the external instrument.
With enabled "RF Coupled" parameter, applies a frequency and level offset. The RF
frequency of the external instrument is calculated as follows:
RF
ExtInstr
= RF A
R&S SMW
+ Delta
Freq
Where both the RF frequency and the frequency offset are applied at the external
instrument.
Remote command:
:SCONfiguration:EXTernal:FADer<ch>:RF:FREQuency on page 847
:SCONfiguration:EXTernal:BBMM<ch>:RF:FREQuency on page 847
:SCONfiguration:EXTernal:IQOutput<ch>:RF:FREQuency on page 847
:SCONfiguration:EXTernal:FADer<ch>:RF:FREQuency:OFFSet on page 847
:SCONfiguration:EXTernal:BBMM<ch>:RF:FREQuency:OFFSet on page 847
:SCONfiguration:EXTernal:IQOutput<ch>:RF:FREQuency:OFFSet
on page 847
:SCONfiguration:EXTernal:FADer<ch>:RF:POWer on page 848
:SCONfiguration:EXTernal:BBMM<ch>:RF:POWer on page 848
:SCONfiguration:EXTernal:IQOutput<ch>:RF:POWer on page 848
:SCONfiguration:EXTernal:FADer<ch>:RF:POWer:OFFSet on page 848
:SCONfiguration:EXTernal:BBMM<ch>:RF:POWer:OFFSet on page 848
:SCONfiguration:EXTernal:IQOutput<ch>:RF:POWer:OFFSet on page 848
RF State
With enabled "RF Coupled" parameter, displays the RF output state of the connected
external instrument. The parameter is coupled to the state of the RF output of the
R&S SMW.
In uncoupled mode, enables/disables the RF output in the external instrument.
Remote command:
:SCONfiguration:EXTernal:FADer<ch>:RF:STATe on page 849
:SCONfiguration:EXTernal:BBMM<ch>:IQConnection:STATe? on page 846
:SCONfiguration:EXTernal:IQOutput<ch>:RF:STATe on page 849
3.4.3.2 External Instrument Configuration Settings
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
System Configuration Settings