Rohde & Schwarz SMW200A - Global Connectors Settings

General Instrument Functions
R&S
®
SMW200A
669User Manual 1175.6632.02 ─ 16
The eye icon in the tab header indicates the panel (front, rear or both) the
selected connector is located at.
Connector
Displays the assigned connector, configured in one of the following ways:
●
Selected in the Global Connectors dialog
●
Selected in the Local Connectors dialog
●
Automatically selected dedicated RF connector, like LO IN/OUT or INST TRIG X
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
A blinking LED on the front/rear panel indicates the selected connector, too (see "Con-
nector status indication" on page 663).
11.2.5 Global Connectors Settings
Access:
1. Perform one of the following:
● In the "Block Diagram", select the T/M/C status LEDs to access the "Trigger
Marker Clock" dialog and:
– Select a global User connector or
– Select "Global Connector Settings"
● Select "Baseband > Custom Digital Modulation > Trigger In > Global Connector
Settings" or respectively the "Trigger In", "Marker" or "Clock" tab of the corre-
sponding digital standard.
● In the "Block Diagram", select the "T/E/P/V" status LEDs to access the "RF
Connectors" dialog and select a global User connector.
Configuring the Local and Global Connectors