Rohde & Schwarz SMW200A - Sine Test Signals

Configuring the Internal Baseband Source
R&S
®
SMW200A
311User Manual 1175.6632.02 ─ 16
4.7.3.2 Sine Test Signals
Access:
► Select "Baseband > ARB > General > Create Test Signal > Sine" and press "Cre-
ate Test Signal".
This dialog provides settings for configuration of a sinusoidal test signal. A sine
wave is generated on the I path, and a sine wave of the same frequency but
phase-shifted is generated on the Q path. For more information, refer to Chap-
ter 4.7.2.2, "ARB Test Signals", on page 301.
The dialog displays the characteristic of the currently selected signal.
Settings:
Frequency................................................................................................................... 311
Samples per Period.....................................................................................................312
Phase Offset Q............................................................................................................312
Generate Signal HD....................................................................................................312
Generate Signal RAM................................................................................................. 312
Frequency
Enters the frequency of the test signal.
Using the Arbitrary Waveform Generator (ARB)