Rohde & Schwarz SMW200A - Source:bb:progress Subsystem General Commands

Remote Control Commands
R&S
®
SMW200A
1024User Manual 1175.6632.02 ─ 16
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 597
[:SOURce]:BB:MEASurement:POWer:EXECute
Example: Triggers the instrument to perform the configured measurement.
Example: See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 597
[:SOURce]:BB:MEASurement:POWer:ABORt
Stops the current measurement.
Example:
See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 597
[:SOURce]:BB:MEASurement:POWer:DELete
Removes the selected measurement from the list.
Example:
See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 597
13.18.4.10 SOURce:BB:PROGress Subsystem General Commands
In the R&S SMW, some calculation processes take longer time. While operating the
instrument manually, you can observe the status of an initiated process by the busy
indicator. The following commands fulfill the same task in the remote control operation.
Example: Querying the status of the Create Waveform file process
The following is an example on how to use these commands to retrieve information
about how many percent of the initiated process are completed.
:SCONfiguration:MODE ADVanced
:SCONfiguration:FADing MIMO4x4
:SCONfiguration:BASeband:SOURce COUPled
:SCONfiguration:APPLy
:SOURce1:BB:EUTRa:SETTing:TMOD:DL "E-TM1_1__15MHz"
:SOURce1:BB:EUTRa:SLENgth 100
SOURce Subsystem