Rohde & Schwarz SMW200A - How to Identify Parameters Which Are Not in a Preset State

File and Data Management
R&S
®
SMW200A
625User Manual 1175.6632.02 ─ 16
(see "Execute Factory Preset" on page 625)
See also Table 10-1 that contains the key parameters that are reset by the correspond-
ing preset functions.
Remote command:
*RST on page 772
Set To Default
Resets the associated settings of the corresponding dialog or tab.
Remote command:
For example, [:SOURce<hw>]:BB:<Digital Standard>:PRESet
Preset this Parameter
Restores the default value of a single parameter.
Execute Factory Preset
Resets the instrument to its factory settings.
Note: "Factory Preset" retains all security settings and does not delete any user files
like setups or user data.
See also Table 10-1 that contains the key parameters that are reset by the correspond-
ing preset functions.
Remote command:
:SYSTem:FPReset on page 775
10.2.2 How to Identify Parameters Which Are Not in a Preset State
To recognize the current state of the settings related to their default values at the first
glance, enable a function that visually identifies parameters in states different than pre-
set.
To activate this display:
1. Open the context-sensitive menu (touch and hold the screen anywhere in the GUI
of the R&S SMW).
2. Select "Mark all parameters changed from preset".
If enabled, the corresponding settings are marked.
Restoring the (Default) Instrument Configuration