Rohde & Schwarz SMW200A - Using a Web Browser with HTML5

Network Operation and Remote Control
R&S
®
SMW200A
761User Manual 1175.6632.02 ─ 16
The VNC Apps are available from various manufacturers of the smart devices. The list
of supported devices is different according to the smart device. Refer to the manufac-
turer's website to find out whether a VNC App is available for your device, and how it is
installed.
1. In the network, establish the connection of the WLAN router to the LAN router.
We assume that the LAN router and the R&S SMW are connected and configured
in the LAN.
2. Configure the WLAN router according to the manufacturer's instructions.
3. Install the required VNC App on your smart device.
4. On the smart device, start the VNC App.
5. In the address field, enter the IP address of the instrument.
Tip: The R&S SMW indicates IP address on the screen.
A log-on dialog opens and requests the password for the VNC connection.
The default user name and password is instrument.
Tip: Default password. Remote access via VNC uses the user name "instrument"
with default user password "instrument".
Note: We recommend that you change the default password before connecting the
instrument to a network.
See Chapter 11.5.4, "Password Management", on page 694.
6. Enter the password to establish the remote access.
After the connection is established, the current screen of the signal generator is
displayed and the instrument can be remotely operated.
12.17.2.2 Using a Web Browser with HTML5
The R&S SMW supports remote operation from a smart device via VNC with any
HTML5 compliant web browser, like Internet Explorer, Firefox, Google Chrome, or
Safari for instance.
To operate the instrument remotely via a web browser, proceed as follows:
1. In the web browser enter the IP address of the instrument, e.g. http://10.113.1.151.
2. Type the instrument IP address in the address field of the web browser on your
PC, e.g. http://10.113.1.151
Tip: The R&S SMW indicates IP address on the screen.
The VNC authentication screen appears.
3. Enter the password and confirm with "OK".
How to Set Up Remote Operation via VNC