Configuring the Signal in the RF Domain
R&S
®
SMW200A
512User Manual 1175.6632.02 ─ 16
7.7.3.4 Overview
► To access this dialog, select "RF > Modulations > Overview".
The "Overview" tab shows the active modulations and the LF signal sources used
by each. In addition, you can modify the settings or activate the analog modula-
tions here. See Chapter 7.7.2.3, "Assigning the LF Signal to the Output",
on page 496 for a detailed explanation of this tab. For all further settings relating to
an analog modulation, see Chapter 7.7.3, "Modulation Settings", on page 502.
7.7.3.5 Pulse Modulation
► To access this dialog, select "RF > Analog Modulation > Pulse Modulation".
Analog Modulations
To Next Page
Loading...
