Configuring the Signal in the RF Domain
R&S
®
SMW200A
513User Manual 1175.6632.02 ─ 16
Table 7-10: Pulse Modulation
"Signal Source > Pulse Generator " (internal) "Signal Source > Pulse Generator " External
The "Pulse Modulation" dialog contains all parameters required to configure pulse
modulation and pulse signal generation. It also displays the pulse signal graphi-
cally.
In the "Pulse Modulation" tab, you can configure the parameters of the modulation sig-
nal, such as trigger mode or transition characteristics, depending on the selected sig-
nal source. For the assignment of an externally applied signal, you can directly access
the settings, see Chapter 11.2.4, "RF Connectors Settings", on page 667.
Settings:
State............................................................................................................................513
Source.........................................................................................................................513
Transition Type........................................................................................................... 514
Video Polarity..............................................................................................................514
Polarity Pulse Input..................................................................................................... 514
Threshold USER4-6 Input/Threshold Pulse Input.......................................................514
Impedance Pulse Input............................................................................................... 514
Set Global Connector for Pulse Modulation................................................................514
State
Activates pulse modulation.
Remote command:
[:SOURce<hw>]:PULM:STATe on page 885
Source
Selects between the internal "Pulse Generator" or an "External" pulse signal for the
modulation.
"Pulse Generator"
Selects the internal generator.
See Pulse Generator.
Analog Modulations
To Next Page
Loading...
