Rohde & Schwarz SMW200A - Rectangular Test Signal

Configuring the Internal Baseband Source
R&S
®
SMW200A
312User Manual 1175.6632.02 ─ 16
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency on page 930
Samples per Period
Enters the number of sample values required from the sine wave per period.
The maximum allowed value is determined by the maximum ARB clock rate (see data
sheet) and the selected frequency.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles on page 930
Phase Offset Q
Enters the phase offset of the sine-wave signal on the Q channel relative to the sine-
wave signal on the I channel.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe on page 930
Generate Signal HD
Generates a signal and saves it as a waveform file on the hard disk. Use the standard
"File Select" function to store this file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed on page 931
Generate Signal RAM
Generates a signal and uses it as output straight away. The instrument stores the file
with a predefined name.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate on page 931
4.7.3.3 Rectangular Test Signal
Access:
1. Select "Baseband > ARB > General > Create Test Signal > Rect".
Using the Arbitrary Waveform Generator (ARB)