Rohde & Schwarz SMW200A - About List Mode

Configuring the Signal in the RF Domain
R&S
®
SMW200A
470User Manual 1175.6632.02 ─ 16
Figure 7-15: Sweep signal sawtooth shape
1 = Start value
2 = Stop value
3 = Step width
●
Triangle
The sweep sequence resembles a triangle. One sweep runs from start to stop
value frequency and back. Each subsequent sweep starts at the start value.
Figure 7-16: Sweep signal triangle shape
1 = Start value
2 = Stop value
3 = Step width
The used sweep parameter (RF frequency, RF level or LF frequency) varies the values
according to the selected shape.
7.6.3 About List Mode
The list mode is used to generate the RF signal based on a set of predefined fre-
quency and amplitude value pairs, with individual step times. You can define the val-
ues arbitrarily, in any order and varying step sizes, within the entire configurable value
range of the instrument.
Varying the RF Signal in List or Sweep Mode