Signal Routing and System Configuration
R&S
®
SMW200A
164User Manual 1175.6632.02 ─ 16
4. Select "Check Connection".
The dialog is a graphical representation of the required connections and their sta-
tus. The connection status indication is color coded.
The dialog shows information on the following:
● Connection check status
● Signal connections status
● Remote control connections status
Remote command:
:SCONfiguration:EXTernal:IQOutput<ch>:CONNections:CHECk?
on page 855
3.4.4 Overview
Access:
► To display an interactive overview diagram of the current configuration, select
"System Configuration > Overview".
The overview tab shows information on the following:
● Current stream mapping to the output interfaces, see Chapter 3.4.2, "I/Q
Stream Mapper Settings", on page 144.
● Connected controller (external PC).
● Connections for remote control of connected external I/Q and RF devices,
Chapter 3.4.3, "External RF and I/Q Settings", on page 147
● Input and output signals, like:
– LO coupling or used external reference frequency.
– Connected external baseband source to the digital input interface.
System Configuration Settings
To Next Page
Loading...
