Rohde & Schwarz SMW200A - How to Create Data and Control Lists

Configuring the Internal Baseband Source
R&S
®
SMW200A
285User Manual 1175.6632.02 ─ 16
The bit position is specified in the "Ramp Position" column, the high or low signal sta-
tus in the "Ramp State" column. Use the last blank row to enter new ramps.
To apply the changes, press "Accept".
Remote command:
n.a.
Zoom/Visible
Zooms the displayed area of the control list. The designation of the button changes
from "Zoom in" to "Zoom out".
With long control lists, it is helpful to display only a part of the control list. In such
cases, set the "Visible/Bits Visible" to determine the number of symbols/bits to be dis-
played and select "Zoom" to focus the displayed area around the current "Cursor Posi-
tion".
Ramps outside the displayed area are not lost by zooming.
Remote command:
n.a.
Save/Save As
Stores the changes in the selected control list file or in a new file.
Remote command:
n.a.
4.6.4 How to Create Data and Control Lists
This section provides step-by-step instructions on configuring and using the provided
settings. For details on individual functions and settings, see Chapter 4.6.3, "Custom
Digital Modulation Settings", on page 265.
Generating Custom Digital Modulated Signals