Rohde & Schwarz SMW200A - Carrier Table Assistant

Configuring the Internal Baseband Source
R&S
®
SMW200A
367User Manual 1175.6632.02 ─ 16
Remote command:
n.a.
!!!
Indicates an occurred conflict by means of a warning triangle. A conflict arises when
the carriers overlap and is also indicated in the header of the "Carrier Table" tab.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:CONFlict?
on page 950
4.9.3.3 Carrier Table Assistant
Access:
1. Select "Baseband > ARB > General > Multi Carrier".
2. Select "ARB: Multi Carrier > Carrier Table > Carrier Table Assistant"
The "Carrier Table Assistant" dialog enables the configuration of a selectable sub-
set of carrier. The provided settings are an optional way to create a multi-carrier
scenario within a specified carrier range.
Settings:
Carrier State................................................................................................................368
Carrier Start/Start........................................................................................................368
Gain Start....................................................................................................................368
Gain Step.................................................................................................................... 368
Phase Start................................................................................................................. 368
Phase Step..................................................................................................................368
Delay Start.................................................................................................................. 369
Generating Multi-Carrier Signals