Rohde & Schwarz SMW200A - I;Q Stream Mapping

Remote Control Commands
R&S
®
SMW200A
840User Manual 1175.6632.02 ─ 16
Example: see Example "Distributing the I/Q streams to the output connec-
tors (advanced configuration)" on page 826
Usage: Event
Manual operation: See "Apply" on page 144
13.17.3 I/Q Stream Mapping
Option: R&S SMW-B10 for commands with the keywords BBMM<ch> and FADer<ch>.
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:STReam<st>:STATe?............................... 840
:SCONfiguration:OUTPut:MAPPing:RF<ch>:STReam<st>:STATe...................................... 840
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:STReam<st>:STATe............................. 840
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:STReam<st>:STATe.................................840
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:MODE?....................................................840
:SCONfiguration:OUTPut:MAPPing:RF<ch>:MODE...........................................................840
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:MODE..................................................840
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:MODE..................................................... 840
:SCONfiguration:OUTPut:MAPPing:STReam<st>:FOFFset................................................841
:SCONfiguration:OUTPut:MAPPing:STReam<st>:POFFset................................................841
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:STReam<st>:STATe? <State>
:SCONfiguration:OUTPut:MAPPing:RF<ch>:STReam<st>:STATe <State>
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:STReam<st>:STATe <State>
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:STReam<st>:STATe <State>
Maps the I/Q output streams to the output connectors.
The stream mapping to the FADER connectors is fixed.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: see Example "Distributing the I/Q streams to the output connec-
tors (advanced configuration)" on page 826
Manual operation: See "Map Stream X to Connector" on page 146
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:MODE? <Mode>
:SCONfiguration:OUTPut:MAPPing:RF<ch>:MODE <Mode>
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:MODE <Mode>
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:MODE <Mode>
Enables routing of multiple streams to the same output physical connector and defines
the way the streams are internally processed.
SCONfiguration Subsystem