Rohde & Schwarz SMW200A - Page 841

Remote Control Commands
R&S
®
SMW200A
826User Manual 1175.6632.02 ─ 16
Example: Distributing the I/Q streams to the output connectors (advanced con-
figuration)
The following example lists the commands necessary to fulfill this task.
// ******************************************************************
// Reset the system configuration and enable a 1x4x4 MIMO fading config
// ******************************************************************
SCONfiguration:PRESet
SCONfiguration:MODE ADVanced
SCONfiguration:FADing MIMO4X4
SCONfiguration:BASeband:SOURce COUPled
SCONfiguration:APPLy
// ******************************************************************
// Map the I/Q streams to the output connectors
// ******************************************************************
SCONfiguration:OUTPut:MAPPing:STReam1:FOFFset 20E6
SCONfiguration:OUTPut:MAPPing:STReam1:POFFset 0
SCONfiguration:OUTPut:MAPPing:RF1:STReam1:STATe ON
SCONfiguration:OUTPut:MAPPing:RF2:STReam2:STATe ON
SCONfiguration:OUTPut:MAPPing:IQOutput1:STReam3:STATe ON
SCONfiguration:OUTPut:MAPPing:IQOutput2:STReam4:STATe ON
// The digital I/Q outputs are not used
SCONfiguration:OUTPut:MAPPing:BBMM1:STReam1:STATe OFF
SCONfiguration:OUTPut:MAPPing:BBMM2:STReam2:STATe OFF
// Alternatively:
// stream A&C and B&D are added and output at BBMM 1 and BBMM 2 outputs
// SCONfiguration:OUTPut:MAPPing:BBMM1:MODE ADD
// SCONfiguration:OUTPut:MAPPing:BBMM2:MODE ADD
// SCONfiguration:OUTPut:MAPPing:BBMM1:STReam1:STATe ON
// SCONfiguration:OUTPut:MAPPing:BBMM2:STReam2:STATe ON
// SCONfiguration:OUTPut:MAPPing:BBMM1:STReam3:STATe ON
// SCONfiguration:OUTPut:MAPPing:BBMM2:STReam4:STATe ON
Example: Connecting and configuring external instrument (advanced configura-
tion)
The following example lists the commands necessary to fulfill this task.
SCONfiguration:EXTernal:DISPlay ALL
SCONfiguration:EXTernal:REMote:CLEan
SCONfiguration:EXTernal:REMote:SCAN
SCONfiguration:EXTernal:REMote:SCAN:STATe?
// 0
SCONfiguration:EXTernal:CODer1:DIRection?
// Response: IN
SCONfiguration:EXTernal:BBMM1:DIRection?
SCONfiguration Subsystem