Rohde & Schwarz SMW200A - Selftest Baseband Settings

Maintenance
R&S
®
SMW200A
1166User Manual 1175.6632.02 ─ 16
Remote command:
:TEST:BB:GENerator:GAIN on page 1144
Frequency
Sets the frequency of the test signal.
Remote command:
:TEST:BB:GENerator:FREQuency on page 1144
Select ARB File
Provides access to the standard "File Select" function of the instrument. The provided
navigation possibilities in the dialog are self-explanatory.
See also, chapter "File and Data Management" in the R&S SMW User Manual.
Remote command:
:TEST:BB:GENerator:ARBitrary on page 1144
14.3.6 Selftest Baseband Settings
Access:
► Select "System Config > Setup > Maintenance > Selftest > Baseband".
In the "Baseband" dialog you can execute the baseband selftest.
The remote command required to start the test is described in Chapter 13.21, "TEST
Subsystem", on page 1141.
Performing Maintenance Tasks