Maintenance
R&S
®
SMW200A
1165User Manual 1175.6632.02 ─ 16
Access:
► Select "System Config > Setup > Maintenance > Selftest > Test Generator".
The "DAC" dialog contains the parameters for testing the IQ signal source.
The remote commands required to define these settings are described in Chap-
ter 13.21, "TEST Subsystem", on page 1141.
State
Starts the test generator.
Remote command:
:TEST:BB:GENerator:STATe on page 1145
IQ Source
Selects the test signal source.
"Sine"
Generates a sine waveform with frequency as set with the parameter
Frequency.
"Constant I/Q"
Uses a constant I/Q test signal.
For more details, see Chapter 4.7.3.4, "Constant IQ Test Signal",
on page 314.
"ARB"
Selects a signal generated by the ARB. Select the waveform file with
the parameter Select ARB File.
Remote command:
:TEST:BB:GENerator:SOURce on page 1144
Gain
Sets the gain for a sine or a constant I/Q test signal.
Performing Maintenance Tasks
To Next Page
Loading...
