Rohde & Schwarz SMW200A - Configuring LAN Services

General Instrument Functions
R&S
®
SMW200A
692User Manual 1175.6632.02 ─ 16
●
The security settings are not assigned until you select the "Accept" button.
Accept
Applies the modified settings, provided the security password is entered and correct.
11.5.3 Configuring LAN Services
Access:
► Select "System Config > Setup > Security > Security > LAN Services".
In the "LAN Services" dialog, you can individually enable or disable the supported
LAN interface services.
The activated LAN services are not activated until you enter the "Security Password"
on page 691 and confirm with Accept.
LAN Interface
Enables the LAN interface in general, and thus provides remote access via all
unlocked services.
Managing the Security Settings