Rohde & Schwarz SMW200A - Trigger Settings

Remote Control Commands
R&S
®
SMW200A
995User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt <Start>
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP <Stop>
Defines the first/last carrier in the carrier range to which joint configuration applies.
Parameters:
<Stop> integer
Range: 0 to 8191
*RST: 0
Example: See "Programming Examples" on page 983
Manual operation: See "Carrier Start/Stop" on page 377
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe <State>
Switches all the carriers in the selected carrier range on or off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example: See "Programming Examples" on page 983
Manual operation: See "Carrier State" on page 377
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute
Adopts the settings for the carrier range.
Example:
See "Programming Examples" on page 983
Usage: Event
Manual operation: See "Accept" on page 378
Trigger Settings
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute.........................................................995
[:SOURce<hw>]:BB:MCCW:TRIGger:EXECute.................................................................996
[:SOURce<hw>]:BB:MCCW:TRIGger:EXTernal:SYNChronize:OUTPut............................... 996
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:DELay................................................. 996
[:SOURce<hw>]:BB:MCCW:TRIGger:OBASeband:INHibit................................................. 996
[:SOURce<hw>]:BB:MCCW:TRIGger:RMODe?.................................................................997
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth................................................................. 997
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce................................................................. 997
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:DELay.................................................... 998
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal]:INHibit.................................................... 998
[:SOURce<hw>]:BB:MCCW[:TRIGger]:SEQuence.............................................................998
[:SOURce<hw>]:BB:MCCW:TRIGger:ARM:EXECute
Stops signal generation.
SOURce Subsystem