Getting Started
R&S
®
SMW200A
103User Manual 1175.6632.02 ─ 16
●
Generation of signals with up to 2 GHz signal bandwidth, for example for WLAN
IEEE 802.11ad signals
●
Generation of fading scenarios, e.g for test setups involving R&S SMW and
R&S
®
CMW
A few examples are given in the following:
● Transmit Diversity Test (MISO Scenario)..............................................................103
● Receive Diversity Test (SIMO Scenario)...............................................................103
● Generation of Signals for Testing of WCDMA Handover (Two Cells)...................104
● Generation of an EUTRA/LTE 8x2 MIMO Signal for UE Tests.............................104
● Generation of an LTE Test Signal with Carrier Aggregation and 2x2 MIMO each
Component Carrier................................................................................................105
● Generation of a WLAN 802.11ad Signal with 1.76 GHz Bandwidth..................... 106
2.4.2.1 Transmit Diversity Test (MISO Scenario)
The block diagram in this example depicts the generation of a test signal using both
internal baseband generators and 1 RF output (RF A).
2.4.2.2 Receive Diversity Test (SIMO Scenario)
The block diagram in this example depicts the generation of a test signal using one
internal baseband generator (Baseband A) and distributing the signal to both RF out-
puts.
System Overview
To Next Page
Loading...
