Rohde & Schwarz SMW200A - Accessing the File System of the R&S SMW Via Ftp

File and Data Management
R&S
®
SMW200A
646User Manual 1175.6632.02 ─ 16
To enable file transfer via ftp
1. Select "System Config > Setup > Security > Security > LAN Services".
2. Enable "LAN Interface"
3. Enable "FTP"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 11.5,
"Managing the Security Settings", on page 686.
5. Select "Accept".
To enable file transfer via SMB (samba)
1. Select "System Config > Setup > Security > Security > LAN Services"
2. Enable "LAN Interface"
3. Enable "SMB (Samba)"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 11.5,
"Managing the Security Settings", on page 686.
5. Select "Accept".
To enable file transfer via USB
1. Select "System Config > Setup > Security > Security > General"
2. Enable "USB Storage"
3. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 11.5,
"Managing the Security Settings", on page 686.
4. Select "Accept".
10.9.2 Accessing the File System of the R&S SMW via ftp
If the R&S SMW is connected to a LAN, you can use file transfer protocol (ftp) to
access the file system and to transfer files from and to the instrument.
For information on how to set up a LAN connection, refer to:
●
Chapter 2.1.4, "Setting Up a Network (LAN) Connection", on page 45
●
Chapter 12, "Network Operation and Remote Control", on page 702
To access the file system via ftp
We assume that the instrument and the remote PC are connected to a LAN.
1. Enable file transfer via ftp
2. Enable write permission on the file system
How to Transfer Files from and to the Instrument