Signal Routing and System Configuration
R&S
®
SMW200A
159User Manual 1175.6632.02 ─ 16
:SCONfiguration:EXTernal:BBMM<ch>:REMote:CONNect on page 851
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:ISELect on page 851
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:CONNect on page 851
Initialization Sequence Settings
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
3. In the "<Dig. Conn. Name>: External Instrument Configuration" dialog, select "Initi-
alization Sequence".
The dialog displays the content of a loaded initialization sequence for remote con-
trol of the connected external instrument from the R&S SMW.
Settings:
Initialization Sequence................................................................................................ 159
Remove Initialization Sequence..................................................................................160
Initialization Sequence
Accesses the standard "File Select" dialog for loading an existing initialization file
(extension *.iec).
Use the "Predefined Settings" function to access a predefined initialization file or navi-
gate to a user-defined one.
When you establish the connection to an external instrument, i.e. Remote Connection
Status is active, the R&S SMW performs the following:
●
Sends the command :DEVice:PRESet
System Configuration Settings
To Next Page
Loading...
