Rohde & Schwarz SMW200A - Page 175

Signal Routing and System Configuration
R&S
®
SMW200A
160User Manual 1175.6632.02 ─ 16
●
Sends the content of the initialization sequence file to reconfigure the external
instrument
If necessary, perform further settings and configuration of the external instruments.
Tip: Try out also the following:
●
Send individual SCPI commands or a sequence of SCPI commands to the connec-
ted instruments or define your own initialization sequence and load the file
See "To create a remote control sequence or modify the initialization sequence"
on page 207
●
If you are configuring the R&S SMW remotely form a controller, try out to remote
control the connected R&S SGS/R&S SGT via the R&S SMW.
See:
– Example "Controlling the R&S SMW and external RF instruments with the
same application program" on page 829
– Example "Connecting an external instrument and sending SCPI commands to
it" on page 832
Remote command:
:SCONfiguration:EXTernal:REMote:INITialization:USER:CATalog?
on page 852
:SCONfiguration:EXTernal:REMote:INITialization:PREDefined:
CATalog? on page 852
:SCONfiguration:EXTernal:CODer<ch>:REMote:INITialization:USER:
FILE on page 853
:SCONfiguration:EXTernal:CODer<ch>:REMote:INITialization:
PREDefined:FILE on page 853
:SCONfiguration:EXTernal:CODer<ch>:REMote:INITialization:FILE?
on page 854
:SCONfiguration:EXTernal:FADer<ch>:REMote:INITialization:USER:
FILE on page 853
:SCONfiguration:EXTernal:FADer<ch>:REMote:INITialization:
PREDefined:FILE on page 853
:SCONfiguration:EXTernal:FADer<ch>:REMote:INITialization:FILE?
on page 854
:SCONfiguration:EXTernal:BBMM<ch>:REMote:INITialization:USER:
FILE on page 853
:SCONfiguration:EXTernal:BBMM<ch>:REMote:INITialization:
PREDefined:FILE on page 853
:SCONfiguration:EXTernal:BBMM<ch>:REMote:INITialization:FILE?
on page 854
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:INITialization:
USER:FILE on page 853
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:INITialization:
PREDefined:FILE on page 853
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:INITialization:
FILE? on page 854
Remove Initialization Sequence
Deletes the loaded sequence.
System Configuration Settings