Maintenance
R&S
®
SMW200A
1168User Manual 1175.6632.02 ─ 16
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option. How to install options is described in
chapter 4 of the R&S SMW service manual.
The installation of hardware options purchased at a later stage is also described in
chapter 4 of the service manual. Most of the hardware options have to be installed at
an authorized Rohde & Schwarz service center.
14.3.8.1 Hardware Configuration Settings
Access:
► Select "System Config > Setup > Instrument Assembly > Hardware Config".
The "Hardware Config" dialog lists all installed assemblies and externally connec-
ted instruments with information on their part and serial numbers, and revision
states. The dialog is divided in tabs, according to the hardware components of the
signal domains. The "Counter" tab provides information on the operation time and
number of times the instrument was powered on.
The remote commands required to query the hardware configuration are described in
Chapter 13.10, "DIAGnostic Subsystem", on page 794.
Assembly
The tables in the tabs show characteristics of the installed assemblies.
Connected external instruments are also shown.
"Path"
Shows the path to that the assembly belongs.
"Assembly"
Assembly designation.
"Part Number"
Part number of the assembly.
"Serial Number"
Serial number of the assembly.
"Revision"
Revision state of the assembly.
Performing Maintenance Tasks
To Next Page
Loading...
