Configuring the Signal in the RF Domain
R&S
®
SMW200A
488User Manual 1175.6632.02 ─ 16
"Frequency /Hz"
Sets the frequency values.
Remote command:
[:SOURce<hw>]:LIST:FREQuency on page 1079
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency on page 1028
"Power /dBm"
Sets the level values.
Remote command:
[:SOURce<hw>]:LIST:POWer on page 1081
[:SOURce<hw>]:CORRection:CSET:DATA:POWer on page 1029
"Dwell /s"
In list mode, sets the dwell time values.
Remote command:
[:SOURce<hw>]:LIST:DWELl:LIST on page 1078
Data handling keys
Standard functions for file and data handling.
Note: Save a list only after filling both columns (frequency and level), otherwise the
entries are lost.
Goto ← Data handling keys
Selects a row for editing.
Edit ← Data handling keys
Enables you to insert, or delete a row or ranges within a list, and provides access to a
dialog for automatic filling.
Fill with Sensor ← Data handling keys
In "UCOR" mode, opens a dialog to configure the settings for automatic filling of user
correction data with an R&S NRP power sensor
See Chapter 7.8.3.3, "Fill with Sensor", on page 535
Save As/Save ← Data handling keys
Stores the list in a file with user-defined name and predefined file extension. To save a
copy or create a file, use the "Save as" function.
Fill Table Automatically
Provides parameters for filling a table automatically with user-defined values.
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
