Rohde & Schwarz SMW200A - Page 502

Configuring the Signal in the RF Domain
R&S
®
SMW200A
487User Manual 1175.6632.02 ─ 16
2. "RF" > "RF Level" > "User Correction" > "Edit User Cor. Data"
List mode data editor User correction data editor
The editor is a table with RF frequency and power value pairs and standard navi-
gation functions.
The "Edit List Mode Data" dialog has an extra column for defining variable dwell
times.
All values in one row have to be defined. Rows with missing values are ignored and
not saved. Values of incomplete rows get lost.
If you use global dwell time in list mode, consider also the following:
●
The instrument uses the value set with Global Dwell Time for all list steps.
●
To save the list, however, you must fill in the "Dwell / s " column in each row,
although the values are not used for generating the signal.
Tip: Use the Fill Table Automatically function to fill the dwell time column automati-
cally.
Settings
Edit List Mode Data.....................................................................................................487
Data handling keys .....................................................................................................488
└ Goto.............................................................................................................. 488
└ Edit................................................................................................................488
└ Fill with Sensor..............................................................................................488
└ Save As/Save............................................................................................... 488
Fill Table Automatically .............................................................................................. 488
Edit List Mode Data
Table with correction or list values.
Varying the RF Signal in List or Sweep Mode