Configuring the Signal in the RF Domain
R&S
®
SMW200A
489User Manual 1175.6632.02 ─ 16
The settings are interdependent; the affected parameters change accordingly if you set
a value.
To fill the table, select "Fill".
Note: Save a list only after filling all columns and rows, otherwise the entries are lost.
"From / Range"
Defines the start line and number of the row to be filled.
"Select Column to Fill"
Selects the respective value, including the unit.
"Start / End Value"
Provides the default values corresponding to the selected column.
"Increment"
Determines the step size.
"Fill"
Fills the table.
Fill both columns and then save the list. Otherwise the entries are
lost.
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...
