Rohde & Schwarz SMW200A - Page 1093

Remote Control Commands
R&S
®
SMW200A
1078User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:LIST:LEARn........................................................................................1080
[:SOURce<hw>]:LIST:MODE........................................................................................ 1081
[:SOURce<hw>]:LIST:POWer........................................................................................1081
[:SOURce<hw>]:LIST:POWer:POINts?.......................................................................... 1082
[:SOURce<hw>]:LIST:RMODe.......................................................................................1082
[:SOURce<hw>]:LIST:TRIGger:EXECute........................................................................1082
[:SOURce<hw>]:LIST:TRIGger:SOURce........................................................................ 1082
[:SOURce<hw>]:LIST:RUNNing?...................................................................................1083
[:SOURce<hw>]:LIST:DWELl <Dwell>
Sets the global dwell time. The instrument generates the signal with the frequency /
power value pairs of each list entry for that particular period.
See also Significant Parameters and Functions.
Parameters:
<Dwell> float
Range: 7E-4 to 100
Increment: 1E-4
*RST: 15E-3
Default unit: s
Example: See Example "Create an RF list and activate the list mode"
on page 1074.
Manual operation: See "Global Dwell Time" on page 483
[:SOURce<hw>]:LIST:DWELl:MODE <DwelMode>
Selects the dwell time mode.
Parameters:
<DwelMode> LIST | GLOBal
LIST
uses the dwell time, specified in the data table for each value
pair individually.
GLOBal
uses a constant dwell time, set with command [:
SOURce<hw>]:LIST:DWELl.
*RST: GLOBal
Example: See Example "Create an RF list and activate the list mode"
on page 1074.
Manual operation: See "Dwell Time Mode" on page 483
[:SOURce<hw>]:LIST:DWELl:LIST <Dwell>
Enters the dwell time values in the selected list in µs.
SOURce Subsystem