Remote Control Commands
R&S
®
SMW200A
1082User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:LIST:POWer:POINts?
Queries the number (points) of level entries in the selected list.
Return values:
<Points> integer
Range: 0 to INT_MAX
*RST: 0
Example: See Example "Create an RF list and activate the list mode"
on page 1074.
Usage: Query only
[:SOURce<hw>]:LIST:RMODe <RMode>
Selects the run mode for processing the list.
Parameters:
<RMode> LEARned | LIVE
LEARned
Generates the signal by replaying the previously learned and
saved data from the temporary memory.
LIVE
Generates the signal by processing the list directly.
*RST: LIVE
Example: See Example "Create an RF list and activate the list mode"
on page 1074.
Manual operation: See "Run Mode" on page 485
[:SOURce<hw>]:LIST:TRIGger:EXECute
Starts the processing of a list in list mode.
Example:
See Example "Create an RF list and activate the list mode"
on page 1074.
Usage: Event
Manual operation: See " Execute Single" on page 482
[:SOURce<hw>]:LIST:TRIGger:SOURce <Source>
Selects the trigger source for processing lists.
The names of the parameters correspond to those in sweep mode. SCPI standard
uses other names for the parameters; these names are also accepted by the instru-
ment. The SCPI names should be used if compatibility is an important consideration.
For an overview, see the following table:
SOURce Subsystem
To Next Page
Loading...
