Rohde & Schwarz SMW200A - Page 281

Configuring the Internal Baseband Source
R&S
®
SMW200A
266User Manual 1175.6632.02 ─ 16
Settings:
State............................................................................................................................266
Set To Default............................................................................................................. 266
Save/Recall.................................................................................................................266
Set according to Standard...........................................................................................267
Symbol Rate................................................................................................................267
Coding.........................................................................................................................267
Power Ramp Control...................................................................................................268
State
Enables/disables digital modulation. Switching on digital modulation turns off all other
digital standards.
The digital modulation is generated in real time (no precalculated signal), and therefore
while the digital modulation is enabled, all parameter changes directly affect the output
signal.
Remote command:
[:SOURce<hw>]:BB:DM:STATe on page 893
Set To Default
Calls default settings. The values are listed in Table 4-10.
Remote command:
[:SOURce<hw>]:BB:DM:PRESet on page 893
Save/Recall
Accesses the "Save/Recall" dialog, that is the standard instrument function for storing
and recalling the complete dialog-related settings in a file. The provided navigation
possibilities in the dialog are self-explanatory.
The filename and the directory, in which the settings are stored, are user-definable; the
file extension is however predefined.
See also Chapter 10, "File and Data Management", on page 619.
Generating Custom Digital Modulated Signals