Configuring the Internal Baseband Source
R&S
®
SMW200A
306User Manual 1175.6632.02 ─ 16
This section comprises the settings necessary to configure the segment to be out-
put and adjust the trigger for the switch between the segments of the multi-seg-
ment waveform. The parameters displayed depend on the selected trigger source.
The provided parameters are identical with the parameters in the section "Next
Segment Trigger In" in the "Trigger" tab; for information see Chapter 4.8.3.5, "Next
Segment Trigger In Settings", on page 342.
●
If the current instrument configuration uses Coupled sources, the dialog displays a
table with of up to 8 rows, where the number of rows corresponds to the number of
selected BB Signals (Tx Antennas) or Entities (Users, Cells).
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...
