Monitoring Signal Characteristics
R&S
®
SMW200A
573User Manual 1175.6632.02 ─ 16
Configure
Opens the "Graphics Configuration" dialog, see Chapter 8.1.3, "Graphics Configuration
Settings", on page 568.
Note: This function is available for enlarged graphical signal displays and in the con-
text menus of the thumbnails.
Stop / Run
Stops the processing of the displayed signal and freezes it.
"Run" continues a stopped displayed signal.
Zoom out
Resets a previous zoom, see also "To zoom into a diagram" on page 584.
Reference Curves
Accesses the dialog for defining reference curves, see "Reference Curve"
on page 573.
Display Units
Changes the units of the X-axis. The available values depend on the generated signal.
Show / Hide marker
Sets two markers to the displayed signal or hides them.
See also:
●
"Using markers" on page 567
●
"To enable markers to readout exact measured data" on page 585
Reference Curve
Enable the indication of up to five configurable reference curves (traces).
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...
