Remote Control Commands
R&S
®
SMW200A
1018User Manual 1175.6632.02 ─ 16
Location and use of the source types is shown in Chapter 8.1.2.2, "Signal Acquisition
Points", on page 565.
[:SOURce]:BB:GRAPhics:SOURce:MUX <Mode>
In :SCONfiguration:OUTPut:MODE DIGMux mode, select which of the multiplexed
streams is displayed.
Parameters:
<Mode> STRA | STRB | STRC | STRD | STRE | STRF | STRG | STRH
*RST: STRA
Example:
SCONfiguration:OUTPut:MODE DIGM
SCONfiguration:APPLy
SOURce1:BB:GRAPhics:MODE PSP
SOURce1:BB:GRAPhics:FFTLen LEN2048
SOURce1:BB:GRAPhics:SOURce DO1
SOURce1:BB:GRAPhics:SOURce:MUX STRA
SOURce1:BB:GRAPhics:TRIGger:SOURce SOFT
SOURce1:BB:GRAPhics:SRATe:MODE AUTO
SOURce1:BB:GRAPhics:ADD MIN
Manual operation: See "Mux Stream" on page 570
[:SOURce]:BB:GRAPhics:FFTLen <Mode>
Sets the FFT size.
Parameters:
<Mode> LEN256 | LEN512 | LEN1024 | LEN2048 | LEN4096 | LEN8192
*RST: LEN2048
Example:
SOURce:BB:GRAPhics:FFTLen LEN2048
Manual operation: See "FFT Length" on page 570
[:SOURce]:BB:GRAPhics:FFTFscale <State>
Defines the normalization of the power values in the power spectrum diagram.
Parameters:
<State> 0 | 1 | OFF | ON
1
Normalized power in dBFS
0
Shows power distribution in dB/Hz
*RST: 0
Example:
SOURce:BB:GRAPhics:FFTFscale PSPectrum
SOURce:BB:GRAPhics:FFTFscale 1
// the power spectrum shows the normalized power in dBFS
SOURce Subsystem
To Next Page
Loading...
