Rohde & Schwarz SMW200A - Page 531

Configuring the Signal in the RF Domain
R&S
®
SMW200A
516User Manual 1175.6632.02 ─ 16
Remote command:
[:SOURce<hw>]:PULM:PERiod on page 882
Pulse Width
Sets the pulse duration of the generated pulse signal.
Note: The pulse width must be at least 20 ns less than the set pulse period.
Remote command:
[:SOURce<hw>]:PULM:WIDTh on page 886
Double Pulse Width
Sets the width of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:WIDTh on page 883
Pulse Delay
Sets the pulse delay. The pulse delay determines the time that elapses after a trigger
event before pulse modulation starts. The pulse delay is not effective for double pulse
generation.
Remote command:
[:SOURce<hw>]:PULM:DELay on page 883
Double Pulse Delay
Sets the delay from the start of the first pulse to the start of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:DELay on page 883
Pulse Output State
Activates the output of the pulse modulation signal.
Remote command:
[:SOURce<hw>]:PGENerator:OUTPut[:STATe] on page 1090
Pulse Output Polarity
Sets the polarity of the pulse output signal.
Remote command:
[:SOURce<hw>]:PGENerator:OUTPut:POLarity on page 1090
Trigger Mode
Selects between continuous triggering or triggering initiated by a trigger event from an
external signal.
"Auto"
Generates the modulation signal continuously.
"Ext Triggered"
Generates the signal each time an external trigger event occurs.
"Ext Single"
Generates the signal triggered by an external trigger event.
"Ext Gated"
Generates the signal triggered by an external gate signal.
Remote command:
[:SOURce<hw>]:PULM:TRIGger:MODE on page 885
Analog Modulations