File and Data Management
R&S
®
SMW200A
633User Manual 1175.6632.02 ─ 16
Accessing and recalling instrument setups
For quick access to a stored instrument setup, assign the appropriate action to the
USER key.
See Chapter 11.3, "Assigning Actions to the User Key", on page 678.
To save and recall instrument settings quickly
1. Select SAVE/RCL > "Operation Mode > Save".
2. Select "Save Immediate 1".
The instrument saves its settings in the intermediate memory 1. The filename and
the storage location cannot be changed.
3. Adapt the instrument settings as required. Select "Save Immediate 2"
4. To restore the settings, select the "Operation Mode > Recall"
5. Select "Recall Immediate 1"
The instrument is restored to the previous state.
6. Select "Recall Immediate 2" to switch to the settings stored in the second file.
To save complete instrument settings
1. Select SAVE/RCL > "Operation Mode > Save".
2. Navigate in the file selection dialog and select a filename and storage location for
the settings file.
3. Select "Save".
A file with the defined name and path and the extension *.savrcltxt is created.
To restore instrument's configuration
Save the configuration as described in "To save complete instrument settings"
on page 633.
1. To restore settings, select SAVE/RCL > "Operation Mode > Recall".
2. To retain the current frequency and level settings, enable "Save/Recall > Exclude
Frequency/Level"
3. Navigate in the file selection dialog and select the filename and storage location of
the settings file.
The settings are restored, but the frequency and level settings are retained; you
can repeat the signal generation with the same settings.
See also Chapter 10.2.3, "How to Recall User Settings Automatically after Preset",
on page 626.
Saving and Recalling Instrument Settings
To Next Page
Loading...
