Configuring the Internal Baseband Source
R&S
®
SMW200A
283User Manual 1175.6632.02 ─ 16
(see also "Control Signals" on page 232)
A separate file with the file extension *.dm_iqc is created for each defined control
signal and held on the instrument's hard disk. Control lists created with the editor
are files in an ASCII file format.
In the "Control Data Editor" dialog, the available marker and control signals are dis-
played color-coded. The "Select Ramp to Edit" is a graphical display of the signal
characteristics. To define the ramp for the individual markers or control signals, tap
on the desired position or use the provided support functions "<Signal> Table" and
"Cursor Position". To simplify the settings, use the predefined preset ramp charac-
teristics in the "<Signal> Preset Type" section. The scaling of the x-axis is always
adapted to the overall length of the control list to provide constant overview of all
defined ramps. For detailed representation, zoom the displayed area around the
current cursor position.
In the "Configure Control Signal" section, a status checkbox indicates whether the
individual marker or control signal is assigned or enabled (see Chapter 4.6.4.1,
"How to Create and Assign a Control List", on page 286).
SCPI command:
[:SOURce<hw>]:BB:DM:CLISt:CATalog? on page 913
[:SOURce<hw>]:BB:DM:CLISt:SELect on page 913
Settings:
Configure Control Signal.............................................................................................283
Select Ramp to Edit.................................................................................................... 283
Total List Length..........................................................................................................284
Preset Type.................................................................................................................284
Cursor Position............................................................................................................284
Positions Control Signal..............................................................................................284
Zoom/Visible............................................................................................................... 285
Save/Save As..............................................................................................................285
Configure Control Signal
Displays the color the marker/control signal has been assigned.
The status checkbox indicates whether the individual marker or control signal is
assigned or enabled (see Chapter 4.6.4.1, "How to Create and Assign a Control List",
on page 286).
Remote command:
n.a.
Select Ramp to Edit
Graphical representation for editing of the marker/control signals.
Refer to Chapter 4.6.4.1, "How to Create and Assign a Control List", on page 286 for
an overview of the editing capabilities of the display.
Remote command:
{[TRACE] LIST [#]: Pos0:State0; Pos1:State1; ...PosN-1:StateN-1}
on page 968
[:SOURce<hw>]:BB:DM:CLISt:DATA on page 916
Generating Custom Digital Modulated Signals
To Next Page
Loading...
