Getting Started
R&S
®
SMW200A
61User Manual 1175.6632.02 ─ 16
1, 2 = Connectors for use in a rack
3 = IEC 625/IEEE 488 connector
4 = REF IN/REF OUT connectors
5 = INST TRIG X connectors
6 = USER X connectors
7 = EFC connectors
8 = LO IN/LO OUT connectors
9 = HDD/SSD system drive
10, 11 = DISPLAY PORT, DVI connectors
12 = LAN connectors
13 = USB/USB DEVICE connectors
14 = AC power supply connection and main power switch
15 = Board designation (CODER, FADER, BBMM)
16 = T/M/C and T/M connectors
17a, 17b = DIG I/Q connectors
18 = EXT X connectors
19 = LF OUT X connectors
20a, b = I/Q, I/Q BAR connectors
21 = Serial number (last six digits in the string 1412.0000.02-<serial number>)
22 = R&S SMW-B10, R&S SMW-B13T and R&S SMW-B14 boards location
The rear panel view differs in particular if the standard or wideband baseband options
are installed. The Figure 2-4 shows a detail view of the rear panel. Shown are only the
different boards.
87
6
3b 9
52
BBMM
CODER
4a
3a
4b
1
654a
3a
Figure 2-4: Detail view: Rear panel of instrument equipped with R&S
SMW-B9 and R&S
SMW-
B13XT(wideband baseband)
1 = R&S SMW-B9 and R&S SMW-B13XT boards location
2 = Board designation (CODER, BBMM)
3a, 3b = DIG I/Q connectors (provided for future use)
4a, 4b = HS DIG I/Q connectors (provided for future use)
5 = ADV DATA/CTRL connectors
6 = T/M/C and T/M connectors (provided for future use)
7 = ADV TRIG and ADV CLK connectors (provided for future use)
8 = EXT X connectors
9 = I/Q, I/Q BAR connectors
Instrument Tour
To Next Page
Loading...
