Rohde & Schwarz SMW200A - Page 872

Remote Control Commands
R&S
®
SMW200A
857User Manual 1175.6632.02 ─ 16
The ...:USER<ch>:... commands determine the global trigger threshold and input
impedance values, that affect all trigger and control signal inputs. The global connector
settings concern to all sweeps, digital modulations, the generation of waveforms or
multi carrier signals, and all digital standards, in both paths.
Refer to Chapter 13.18.7, "SOURce:INPut Subsystem", on page 1047 for description
of the commands for configuring the inputs for external modulation signals.
Required options
See Chapter 11.2.1, "Required Options", on page 661.
Example: Global connectors settings configuration
:SOURce1:INPut:USER1:DIRection INP
:SOURce1:INPut:USER1:SIGNal TRIG1
:SOURce1:INPut:USER3:DIRection INP
:SOURce1:INPut:USER3:SIGNal NSEGM1
:SOURce1:INPut:USER4:DIRection INP
:SOURce1:INPut:USER4:SIGNal IPULSA
:SOURce1:INPut:USER5:DIRection INP
:SOURce1:INPut:USER5:SIGNal TRIG2
:SOURce1:INPut:USER:TRIGger:LEVel 1.5
// the signal threshold at USER 1-3 is 1.5 V
// this applies to all input signal, i.e. TRIG1 and NSEGM1
:SOURce1:INPut:USER:PULM:LEVel 2
// the signal threshold at USER 4-6 is 2 V
// this applies to all input signal, i.e. IPULSA and TRIG2
:SOURce1:INPut:USER1:TRIGger:IMPedance G1K
:SOURce1:INPut:USER1:TRIGger:SLOPe POS
:SOURce1:INPut:USER2:DIRection OUTP
:OUTPut1:USER2:SIGNal MARKA2
:SOURce1:INPut:USER6:DIRection OUTP
:OUTPut1:USER6:SIGNal MTR
:OUTPut1:USER6:TRIGger:IMMediate
[:SOURce<hw>]:INPut:TM<ch>:DIRection........................................................................858
:OUTPut<hw>:TM<ch>:DIRection....................................................................................858
[:SOURce]:INPut:USER<ch>:DIRection............................................................................858
:OUTPut:USER<ch>:DIRection....................................................................................... 858
[:SOURce<hw>]:INPut:TM<ch>:SIGNal............................................................................859
:OUTPut<hw>:TM<ch>:SIGNal........................................................................................859
[:SOURce]:INPut:USER<ch>:SIGNal............................................................................... 860
:OUTPut:USER<ch>:SIGNal........................................................................................... 861
:OUTPut:USER<ch>:TRIGger[:IMMediate]....................................................................... 861
[:SOURce]:INPut:USER:CLOCk:LEVel.............................................................................862
[:SOURce]:INPut:USER:TRIGger:LEVel...........................................................................862
[:SOURce]:INPut:USER:PULM:LEVel.............................................................................. 862
[:SOURce]:INPut:USER:CLOCk:IMPedance..................................................................... 862
SOURce Subsystem