Remote Control Commands
R&S
®
SMW200A
861User Manual 1175.6632.02 ─ 16
:OUTPut:USER<ch>:SIGNal <Signal>
Sets the control signal that is output at the selected connector.
To define the connector direction, use the command :OUTPut:USER<ch>:
DIRection.
Suffix:
USER<ch>
.
1 to 6
Parameters:
<Signal> MARKA1 | MARKA2 | MARKA3 | MARKB1 | MARKB2 |
MARKB3 | MARKC1 | MARKC2 | MARKC3 | MARKD1 |
MARKD2 | MARKD3 | SVALA | SVALB | OPULSA | OPULSB |
SYNCA | VIDEOA | VIDEOB | SYNCB | NONE | MTRigger |
RTRIGA | RTRIGB | SVALANegated | SVALBNegated |
SYNCOUT | BERRESTOUT | BERDATENOUT | BERCLKOUT |
BERDATOUT | SCLock | LATTenuation | BGATe | HOP |
CWMODulation | TRIGgered
MARK<A|B|C|D><1|2|3> = Baseband <BB> Marker 1/2/3
SVALA|SVALB = Signal Valid A/B, available for USER4|5|6
SVALAN|SVALBN = Signal Valid A/B (negative), available for
USER4|5|6
OPULSA|OPULSB = Pulse Out A/B, available for USER4|5|6
SYNCA|SYNCB = Sync A/B, available for USER4|5|6
VIDEOA|VIDEOB = Video A/B, available for USER4|5|6
MTRigger = Manual Trigger, available for USER6
RTRIGA|RTRIGB = REG trigger A/B, available for USER4|5
SYNCOU = Baseband Sync Out
*RST:
MARKA1
Example: See Example "Global connectors settings configuration"
on page 857
Options: SYNCOUT requires R&S SMW-B9
Manual operation: See "Signal" on page 671
:OUTPut:USER<ch>:TRIGger[:IMMediate]
Generates a short pulse signal and outputs it at the USER 6 connector.
This signal can serve as a common external trigger signal for triggering of several
R&S SMW, see Example "Triggering several R&S SMW instruments simultaneously"
on page 614.
Suffix:
USER<ch>
.
6
Example: See Example "Global connectors settings configuration"
on page 857
Usage: Event
SOURce Subsystem
To Next Page
Loading...
