Rohde & Schwarz SMW200A - Page 873

Remote Control Commands
R&S
®
SMW200A
858User Manual 1175.6632.02 ─ 16
[:SOURce]:INPut:USER:TRIGger:IMPedance................................................................... 862
[:SOURce]:INPut:USER:CLOCk:SLOPe...........................................................................862
[:SOURce]:INPut:USER:TRIGger:SLOPe......................................................................... 863
[:SOURce<hw>]:INPut:TM:CLOCk:LEVel......................................................................... 863
[:SOURce<hw>]:INPut:TM:TRIGger:LEVel....................................................................... 863
[:SOURce<hw>]:INPut:TM:CLOCk:IMPedance................................................................. 863
[:SOURce<hw>]:INPut:TM:TRIGger:IMPedance................................................................863
[:SOURce<hw>]:INPut:TM:CLOCk:SLOPe....................................................................... 864
[:SOURce<hw>]:INPut:TM:TRIGger:SLOPe......................................................................864
[:SOURce<hw>]:INPut:TM<ch>:DIRection <Direction>
:OUTPut<hw>:TM<ch>:DIRection <Direction>
Determines whether the connector is used as an input or an output.
Suffix:
OUTPut<hw> |
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
OUTPut1|SOURce1 = Baseband A/C and
OUTPut2|SOURce2 = Baseband B/D
TM<ch> 1|2|3
Determines the local connector, where:
OUTPut1:TM1|2|3=SOURce1:INPut:TM1|2|3 = TMC1/2/3
of Baseband A/C and
OUTPut2:TM1|2|3=SOURce2:INPut:TM1|2|3 = TMC4/5/6
of Baseband B/D
Parameters:
<Direction> INPut | OUTPut
*RST: OUTPut
Manual operation: See "T/M/(C) Connector Direction" on page 675
[:SOURce]:INPut:USER<ch>:DIRection <Direction>
:OUTPut:USER<ch>:DIRection <Direction>
Determines whether the connector is used as an input or an output.
Suffix:
USER<ch>
.
1 to 6
Parameters:
<Direction> INPut | OUTPut | UNUSed
UNUSed = the connector is not defined
Example: See Example "Global connectors settings configuration"
on page 857
Manual operation: See "User 1 .. 6 Connector Direction" on page 671
SOURce Subsystem