Getting Started
R&S
®
SMW200A
95User Manual 1175.6632.02 ─ 16
Figure 2-14: System Configuration in the Advanced Mode (1x2x2 configuration)
1 = Advanced mode, required for configuration of complex LxMxN MIMO scenarios
2 = Current signal routing; 2x2 MIMO configuration
3 = Separated and coupled baseband sources
4 = Simplified preview diagram of the particular configuration
2. Leave all further settings, i.e. the "I/Q Stream Mapper" settings, at their default val-
ues and close the "System Configuration" dialog.
The block diagram displays the selected configuration.
To generate an EUTRA/LTE signal in the 2x2 MIMO scenario
1. In the block diagram, select "Baseband > EUTRA/LTE", select "State > On", and
close the dialog.
Trying Out the Instrument
To Next Page
Loading...
