Troubleshooting and Error Messages
R&S
®
SMW200A
1174User Manual 1175.6632.02 ─ 16
Error
Code
Error Description Remedy
182 Adjustment data missing Adjustment data is missing. The adjustment data has to be generated
first by an internal or external adjustment
or to be loaded into the instrument.
183 Adjustment data invalid Adjustment data is invalid and must be restored. The adjustment data has to be generated
again by an internal or external adjust-
ment or to be loaded into the instrument.
200 Cannot access hardware The data transmission to a module was unsuc-
cessful.
The module is not installed, not properly
installed or missing.
201 Hardware revision out of
date
A later version of certain parts of the instrument is
necessary to execute the function selected.
The driver does not support the installed
version of a module.
202 Cannot access the
EEPROM
An error occurs when writing or reading a
EEPROM.
The EEPROM might be defect and has
to be replaced.
203 Invalid EEPROM data Reading a EEPROM is possible, however the data
are inconsistent.
204 Driver initialization failed Initialization of a driver fails when booting the
instrument firmware.
The driver is not compatible with the
hardware or software configuration of the
instrument.
241 No current list There is no list selected. To execute the required
operation, a list has to be selected in the related
dialog. If no list is available, a new list must be cre-
ated.
242 Unknown list type speci-
fied
The list type selected is not valid for the required
operation.
For instance, the file extension for waveform list
files is *.wv. It is not possible to enter another file
extension when selecting a list.
Check the selected list type.
261 Waveform Protected The selected waveform file cannot be transferred
to a controller. The waveform is produced with
simulation software R&S WinIQSIM2 and is pro-
tected.
460 Cannot open file The selected file cannot be opened. Check the path and file name.
461 Cannot write file The file cannot be written. Check if the file is read-only.
462 Cannot read file The file cannot be read. Check if the file contents are compatible
with the file type.
463 Filename missing The required operation cannot be executed
because the file name is not specified.
Enter file name when creating list.
Device-Specific Error Messages
To Next Page
Loading...
